Tips For Replacement of a Hot Water Heater

When your hot water heater requires replacing, it’s crucial to find a dependable brand and model properly installed by a trusted plumber in your neighborhood or business. A plumber is trained in installing all types of plumbing systems and will be able to assess your hot water heater’s requirements and help you choose the most suitable solution for you depending on your hot water supply, your plumbing skills and budget. It is possible to install a new hot water heater yourself if you are confident of doing so and have the right tools, but this is not usually recommended. There are too many mistakes that people make when they try to replace their own water heaters that can be avoided with a little bit of research and skill.

Some people assume that the average cost for a hot water heater replacement is between $500 and $1000. However, this price varies greatly depending on the brand and type of appliance you are looking to replace. The manufacturer of the unit may offer the lowest price around, but do not expect to receive a refund if your chosen brand is not available when you need it. The average cost is more likely to be between two thousand and six thousand dollars for a complete replacement. This will be considerably cheaper if you are replacing an old, out of date, leaky unit.

If you want to save money, or if your hot water heater is a rare antique that you don’t want to replace, you should consider buying a used hot water heater replacement. There are several advantages to doing this: you will probably find a better quality unit that is still under warranty; you can take advantage of factory financing options; and, perhaps most importantly, you can save a significant amount of money over the life of the warranty. However, there are some disadvantages as well. For example, the savings you realize by buying a used model may not be enough to offset the higher cost of repairs or a new, more efficient model. In addition, most manufacturers of new, hot water heaters offer some form of extended warranty to cover replacement expenses in the event that problems develop after purchase.

One option that is becoming popular with homeowners looking to save money on their utility bills is to replace their heaters with natural gas or propane heaters. While these heaters have an initial higher installation cost, they are more energy efficient and use less fuel than standard heaters. Natural gas and propane hot water heater replacement cost are about double that of standard units, while the cost of these units has been steadily dropping over the past few years.

A hot water heaters installation requires only a few basic tools and a few hours of work. Before beginning the job, make sure you disconnect any existing connections and turn off the main power source to eliminate any risk of electrocution. Once connected, remove the old thermostat from the tank and discard it. You will need to locate the appropriate water supply and place it where the tank was located. Connect the tank valve and place the new thermostat into the opening on the side of the house where the water pipe runs through.

If desired, there are numerous options for temperature control; however, it is unlikely that you will require such a feature unless you live in a very cold region or have very expensive, power-sucking plants in your yard. In most cases, you can opt for a thermostatic pump; however, you may need to install a new heating line from your existing water tank to the new pump. Although this will increase the total cost of your heater replacement, it will likely be a less costly option than purchasing a new tank and line from a local hardware store. Finally, when the hot water is delivered to the house, you will need to connect it to an existing hot water meter and then hook the newly purchased thermostat up to the hot water supply.

Leave a Reply

Your email address will not be published. Required fields are marked *